Husqvarna 525DEPS Operator's Manual page 15

Note:
If the engine stops, do the procedure
again.
About the surface
WARNING:
body in the grey marked area. If you
touch the grey marked area it can result
in burns to the skin. It can also cause
electrical shock if the spark plug cap has
been damaged. Do not use a product
with a damaged spark plug cap.
To start a warm engine
WARNING:
instructions in the safety chapter before
you start the product (refer to
page 4 ).
1. Use protective gloves.
2. Push the air purge bulb 10 times.
3. Hold the body of the product on the ground with
your left hand.
CAUTION:
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope with your right
hand until you feel some resistance (the starter
pawls grip).
WARNING:
starter rope around your hand.
6. Pull the cord quickly and with power.
CAUTION:
starter rope all the way out and do
not let go off the starter rope handle
when the starter rope is fully
extended. This can cause damage to
the product.
1480 - 007 - 15.02.2021
Do not put parts of your
Read the warning
Safety on
Do not use your feet!
Do not twist the
Do not pull the
7. Pull the starter rope again and again until the
engine starts.
To stop the product
1. Move the stop switch into the stop position to
stop the engine.
CAUTION:
automatically goes back to its initial
position. In order to prevent
accidental starting, the spark plug
cap must be removed from the spark
plug when assembling, checking
and/or maintenance is done.
To do a run-in
• During the first 10 hours of operation, do not
apply full throttle without load for extended
periods.
To use the product
• Hold the product as close to your body as
possible to get the best balance. Use the
harness to support the weight of the machine
and make it easier to handle.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all
the branches have been cut back cleanly.
• Always slow the engine to idle speed after each
working operation. Long periods at full throttle
without any load on the engine can lead to
serious engine damage.
• Always work at full throttle.
• Whenever possible position yourself so that you
can make the cut at right angles to the branch.
The stop switch
15