LawnMaster GT1450 Operator's Manual page 16

MAINTENANCE
WINDING NEW LINE ONTO A SPOOL (See Figures 18, 19, & 20)
• You may wind new cutting line ⑥ onto an empty spool.
• Replacement packs of cutting line ⑥ are available from dealer.
• Remove the empty spool from the grass trimmer as described above.
• Remove any remaining cutting line ⑥ from the spool.
• Prepare 2 cutting lines ⑥ with the same length for winding. There are 4 eyelets ⑦ in the spool,
2 eyelets ⑦ in the upper section and 2 eyelets ⑦ in the lower section.
• First feed 4 inches of cutting lines ⑥ into the two eyelets ⑦. Two eyelets ⑦ should be in the
different sections of spool.
• Wind the cutting lines ⑥ onto the spool in the direction of the arrow showed on spool. Make sure
to wind the line ⑥ on neatly and in layers. Do not criss-cross.
• After winding, fix the end of line ⑥ in the parking slot of spool.
• If you want to use, operate as described above to fix the spool on the grass trimmer. Do not
forget to release the cutting line ⑥ from the parking slot.
WARNING
Only use the appropriate type of cutting line.
Fig. 18 Fig. 19
16
Fig. 20