LawnMaster GT1450 Operator's Manual page 11

ASSEMBLY
FITTING THE AUXILIARY HANDLE
Loosen and remove the wing nut and bolt from the auxiliary handle.
1. Place the auxiliary handle on the upper shaft. Adjust the handle to mount on the index channel
as shown.
2. Along the index channel, slide the auxiliary handle to the most comfortable position.
3. Insert the bolt in the hole on the auxiliary handle and tighten the wing nut securely.
Fig. 7-1
JOINING THE UPPER SHAFT TO THE MOTOR HEAD
1. Align the upper shaft with the lower shaft.
2. Insert upper shaft into the lower shaft and lock pin button into place.
NOTE:
If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
WARNING
Never adjust the upper handle while the power head is running. Failure
to stop the motor may cause serious personal injury
(See Figure 7& Figure 8.)
Fig. 7-2
Fig. 9
11
(See Figure 9.)
Fig. 8