SonicWALL NSa Series Getting Started Manual page 37

8. Assign the current interfaces to your new firewall on the interface map.
9. Click Next.
10. Select the target version from the drop-down list.
11. Click Finish. The old file is converted based on the parameters you gave. When done the new file is
downloaded so you save it to your local system.
TIP: You should reset the firewall to factory defaults before importing the configuration file (not
required if the device is fresh out of the box).
12. If not already done, register the firewall and upgrade the firmware.
13. Upload the newly created file settings.
14. Check the DNS settings (configure them manually, if needed).
15. Reboot the firewall.
SonicOS 7 Getting Started Guide for the NSsp 13700 and NSa Series 37
Migration Tool