Port or Setting IP Address / Login / Password
Console
Serial port baud rate = 11520
l
Data: 8
l
Parity = none
l
Stop = 1
l
Flow control = none
l
Login = techsupport / sonicwall-<build number>
l
X0
192.168.1.254
X1
Not set by default
Management
192.168.168.168
SafeMode
SafeMode is accessed through the MGMT port which is by default
https://192.168.1.254
unavailable; otherwise, the administrator's credentials should work. For detailed
information about accessing SafeMode, refer to the
MySonicWall
Register on
System Startup
Once the firewall is connected to a power source, SonicOS comes up within a few minutes. You can configure the
firewall from either the X0 or MGMT interface. The X0 interface can be configured as a static, transparent, or
Layer-2, Bridged-Mode interface. The MGMT port is a dedicated 1 Gigabit Ethernet interface for appliance
management and SafeMode access.
To configure HTTPS management via X0:
1. Connect your management computer to the X0 interface. DHCP addressing is available by default on X0.
2. In your browser, enter the default IP address
credentials:
Username: admin
Password: password
3. Refer to
Basic Configuration
To configure HTTPS management via MGMT port:
1. Connect your management computer to the MGMT interface.
2. Configure your computer with a static IP address on the
3. In your browser, enter the default IP address
credentials:
Username: admin
. The login credentials are admin / password if SonicOS is
https://mysonicwall.com
https://192.168.168.168
for the remaining steps for a basic configuration.
https://192.168.1.254
SonicOS 7 Getting Started Guide for the NSsp 13700 and NSa Series
SonicOS 7 Upgrade
to set up an account
192.168.1.0/24
and log in using the default
Guide.
and log in using the default
subnet, such as
192.168.1.20
System Setup
.
22