Operation - Makita DTW280 Instruction Manual

Hook
► Fig.11: 1. Hook 2. Screw 3. Groove
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

CAUTION:
• Always insert the battery cartridge all the way
until it locks in place. If you can see the red part
on the upper side of the button, it is not locked
completely. Insert it fully until the red part cannot
be seen. If not, it may accidentally fall out of the
tool, causing injury to you or someone around
you.
► Fig.12
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Model DTW280
Standard bolt
N m
280
240
200
160
120
80
M12
40
0
0.5
Fastening time (S)
M20
M20
M16
M16
M12
2.0
1.0 1.5
High tensile bolt
N m
280
240
200
160
120
80
40
0
Fastening time (S)
Model DTW281
Standard bolt
N m
280
240
200
160
120
80
40
0.5
0
Fastening time (S)
9 ENGLISH
M14H
M12H
1.0 2.0
M20
M16
M16
M12
M12
1.0 1.5
M16H
M16H
M14H
M12H
3.0
M20
2.0