DMTA020-01EN, Rev. D, September 2016
When the probes are perpendicular to the weld and the scanning direction is parallel
to the weld, the Mini-Wheel encoder is installed on the outside of the encoder holder
(see Figure 1-5 on page 14).
Weld
Figure 1-5 The Mini-Wheel encoder installed on the outside of the encoder holder
When the probes are parallel to the weld and the scanning direction is parallel to the
weld or when the probes are perpendicular to the weld and the scanning direction is
also perpendicular to the weld, the Mini-Wheel encoder is installed on the inside of
the encoder holder (see Figure 1-6 on page 15).
14
Chapter 1
Figure 1-4 The Mini-Wheel encoder and cable
Scan direction