Troubleshooting Guide - Blaupunkt Phoenix MP33 Operating And Installation Instructions

Maintenance
Replacing the Fuse
If the fuse is blown, check the power connection first and then
replace the fuse. If the fuse blows again under normal condi-
tions, the unit may be defective.
Back of the unit
Warning
Use only a fuse with the specified amperage (10 A).
Use of another type of fuse can result in a fire or unit damage.
Cleaning the Connectors
If the connectors of the unit and the front panel are contami-
nated, malfunctions may occur.
Detach the front panel and clean the connectors with an alco-
hol dampened cotton swab as shown below.
Main unit Back of the front panel
Returning to the Initial Settings
When the EJECT button is pressed for more than 10 sec-
onds, the microcomputer of the unit returns to the initial set-
tings. If the display window is not properly shown or the unit
malfunctions, press the EJECT button for more than 10 sec-
onds.
phnx33_body 17
Removing the Unit
Use the supplied release keys when you need to remove the
unit from the car.
Insert them into the unit as shown below. This will unlock the
unit from the sleeve, allowing for removal of the unit.
Note
• Handle the release keys carefully to avoid injuring your fin-
gers.
• Keep the release keys in a safe place for future use.

Troubleshooting Guide

The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Trouble Cause/Solution
• Memorized stations and Leads are not matched
correct time are erased. correctly with the car's
• The fuse has blown. accessory power
• Radio works when the igni- connector.
tion key is the ON, ACC and
Check wiring for short
OFF positions.
circuits.
• No power is being supplied
to the unit.
• The power is continuously
The car doesn't have an
supplied to the unit.
ACC position.
Radio reception
Trouble
Cause/Solution
Preset stations are not re- The broadcast signal is too
ceivable.
weak.
Seek tuning is not possible
The broadcast signal is too
weak. → Use manual tuning.
Travel Store feature does Not enough broadcast frequen-
not complete storing of six cies are receivable.
stations.
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
03/4/22, 17:38
E-17