Troubleshooting Guide; Specifications - Blaupunkt BPV 660 User Manual

Troubleshooting Guide
Specifications
The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Trouble
. Memorized stations and
correct time are erased.
. The fuse has blown.
. Radio works when the igni-
tion key is the ON, ACC and
OFF positions.
- No power is being supplied
to the unit.
Cause/Solution
Leads are not matched
correctly with the car's
accessory power
connector.
Check wiring for short
circuits.
l
The power is continuously
The car doesn't have an
supplied to the unit.
ACC position.
Radio reception
Trouble Cause/Solution
Preset stations are not re- The broadcast signal is too
c&able. weak.
Seek tuning is not possible The broadcast signal is too
weak. i Use manual tuning.
Travel Store feature does Not enough broadcast frequen-
not complete storing of six ties are receivable.
stations.
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call l-800-266-2528 for technical assistance,
parts and service. Call l-800-950-2528 for dealer referral or
to request product brochure.
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest Blaupunkt dealer.
GENERAL
Dimensions
Power requirements :
Output Power :
Message Possible cause
Recommended action
E-01 Dirty disc. Clean the disc.
Scratched disc. Replace the disc.
Up-side-down. Check the disc.
E-02 Focus error. Try ejecting and re-insert-
ing under normal tempera-
ture conditions.
E-03
Data and focus error. Under normal temperature
conditions, eject and insert
clean, undamaged disc
properly.
E-04
Mechanical problem.
Eject and re-insert.
E-05 Loading/Eject error.
Eject and re-insert.
CD Changer Troubleshooting
When problems should develop while operating CD changer,
an error message appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists or "E-03" and
"E-05" appears, contact your nearest Blaupunkt dealer.
Message Possible cause
Recommended action
no dlSC
no-d
No magazine.
No disc.
Load the magazine in
the CD changer.
Check the disc.
E-01
Up-side-down.
Focus error.
Check the disc.
Communication error. Check the connection of
L-UC
the CD changer.
E-04
Excessive
tempera-
The error
Sign Will go Off
ture conditions at
and play will resume
the CD changer.
when the temperature to
Output Wiring :
Output Impedance :
Low - Level Output :
TUNER
Tuning Range
Sensitivity
FM
Stereo Separation :
CD PLAYER
Frequency
Response
S/N Ratio
Wow & Flutter :
OTHER
Remote Control Options:
CD Changer Cable :
AUX Input Cable :
Approx. 178 mm x 50 mm x 155 mm
(WxHxD)
12 volts DC car battery
(negative ground)
RMS and Peak Power ratings (188
watts)
230 watts157.5 peak x 4ch
Floating-ground type designed for 4
speaker use.
RCA low-level outputs (2 channels).
Compatible with 4-8 ohm speakers.
2 v.
AM : 530 1.710 kHz (10 kHz step)
FM : 87.5 - 107.9 MHz (200 kHz step)
AM : 20 pV
FM : 9.1 dBf mono sensitivity
35 dB
20 20,000 Hz
98 dB
Below the measurable limit
RC-823 Credit Card Remote
p/n FOOE500029
p/n 7 607 897 093
E-l 1
a normal ranoe