Adjusting And Installing The Cutting Unit - Toro Greensmaster e1021 Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Certificate of Compliance
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Adjusting and Installing the
Cutting Unit
Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
1
Toro distributor)
1 Coupler
1 Reel driveshaft
4
Socket-head screw
Disassembling the Reel-Drive
Assembly
Perform the following steps to remove the existing
reel driveshaft on your cutting unit:
1. Remove the hardware that secures the reel-drive
assembly to the side plate
Description
Cutting unit (order separately; contact
your authorized Toro distributor)
Coupler
Reel driveshaft
Socket-head screw
Transport Wheel Kit (order separately;
contact your authorized Toro distributor)
Grass basket
No parts required
(Figure 3).
Qty.
1
1
1
4
1
1
–
Qty.
1
Read or view the items before operating the machine.
1
1. Socket-head screw
2. Spacer
3. Washer
2. Remove the reel-drive assembly, flat washers,
spring washers, and spacers from the side plate
(Figure
3. Remove the belt cover to expose the belt
4).
6
Use
Adjust and install the cutting unit to the
machine.
Install the transport wheels (optional).
Install the grass basket.
Mount the battery charger on a wall
(optional).
Use
Figure 3
4. Spring washer
5. Nut
3).
g333187
(Figure