Toro Greensmaster e1021 Operator's Manual page 11

Clutch Bail
Use the clutch bail (Figure
the traction drive.
•
Engage the traction drive: Pull up and hold the
bail to the handle.
Traction speed can vary by how far you pull up
the bail. Pulling the bar up to handle will move
the machine at the maximum set speed; pulling
it slightly up will move the machine at a slower
speed.
•
Disengage the traction drive: Release the bail.
Speed Control
Use the speed control
machine speed.
•
Increase the machine speed: Rotate the lever
down.
•
Decrease the machine speed: Rotate the lever
up.
Key Switch
The switch (Figure 11) allows you to start or shut off
the machine.
•
Start the machine: Move the key to the O
position.
•
Shut off the machine: Move the key to the O
position.
Service-Brake Lever
Use the service brake
machine. Pull the lever toward the handle to engage
the service brake.
Parking-Brake Latch
Use the parking-brake latch
parking brake while you are away from the machine.
•
Engage the parking brake: Engage and hold the
service-brake lever and rotate the parking-brake
latch toward you.
•
Disengage the parking brake: Pull the
service-brake lever toward the handle.
Cutting-Unit-Drive Lever
Use the cutting-unit-drive lever
or disengage the cutting unit.
•
Engage the cutting unit: With the clutch bail in
the neutral (disengaged) position, move the lever
down.
•
Disengage the cutting unit: Move the lever up.
11) to engage or disengage
(Figure 11) to adjust the
(Figure 11) to slow or stop the
(Figure 11) to engage the
(Figure 11) to engage
Hour Meter
The hour meter
of hours that the key switch has been in the O
position. Refer to the meter for scheduling regular
maintenance.
InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine and battery pack, such as the current
battery charge, speed, diagnostics information, and
more (Figure
For more information, refer to
LCD Display (page
Lift-Assist Handle
Use the lift-assist handle
adjusting the handle height or to raise and lower the
kickstand.
Handle-Height Adjuster
Use the handle-height adjuster
the handle height to a comfortable operating position.
Pull up on the adjuster and use the lift-assist handle
N
to raise or lower the handle height.
FF
1. Handle-height adjuster
Kickstand
The kickstand
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
T
RANSPORT
11
(Figure 11) records the total number
11).
Using the InfoCenter
17).
(Figure 11) to help with
(Figure
Figure 12
(Figure 13) is mounted to the rear of
-W -S position:
HEEL ERVICE
N
12) to move
g271081