Setup
c. 400V, 3 phase: Connect power leads to L1, L2,
and L3. Connect neutral to N. Connect green to
ground (GND).
L1
L3
L2
N
Some 3-phase models utilize a 3-phase motor. The
motor must rotate counterclockwise when viewed
from shaft end. To reverse rotation, disconnect
power and reverse power leads L1 and L2.
5. Connect power source to motor
See F
. 1. Connect air supply line (U) to air
IG
regulator kit inlet. See Technical Data on page
34 for inlet sizes, recommended hose sizes, and
air consumption requirements.
16
GND
ti2725a
6. Connect feed pumps
a. Install feed pumps (K) in component A and B
supply drums. See F
and 10.
b. Seal component A drum and use desiccant
dryer (M) in vent.
c. Install agitator (L) in component B drum, if nec-
essary.
d. Ensure A and B inlet valves (FV) are closed.
FV
Supply hoses from feed pumps should be 3/4 in.
(19 mm) ID.
Model HT heat packages only: connect propor-
tioner hoses to npt(f) connections on heater inlet
blocks.
. 1 and F
. 2, pages 9
IG
IG
ti3590a
312407C