Table of Contents
Advertisement
B
Press the [Vacuum Power] button to turn on vacuum.
C
Press [RUN] on the Vacuum Controller.
D
Press the [Vacuum Area] button to turn on the vacuum corresponding to the position the object to
be printed on is in place.
IMPORTANT
If more than one [Vacuum Area] button is pressed simultaneously, negative pressure temporarily
may become insufficient, failing to secure the object to be printed on firmly. If this is the case, wait
until negative pressure becomes stabilized or press the [Vacuum Area] buttons at intervals.
E
Adjust the negative pressure applied to the object to be printed on by turning the knob on the
Vacuum Controller clockwise or counterclockwise.
MEMO
If the object to be printed on cannot be secured firmly, try the following.
• Change the areas to apply the negative pressure using the [Vacuum Area] buttons.
" P. 6 "Flat table"
• To increase the output, turn the knob on the Vacuum Controller clockwise.
To decrease the output, turn the knob counterclockwise.
1.Printing Operations
Printing method
37
Advertisement
Table of Contents
