Charging The Battery - Shark Vertex IZ440 Series Owner's Manual

CHARGING THE BATTERY

USING THE LI-ION CHARGER
LI-ION CHARGER
Plug the Li-Ion Charger into a wall outlet.
IN THE VACUUM: MULTIFLEX®
To put the vacuum in storage mode, press the
MultiFLEX Wand Unlock Latch while folding the
handheld vacuum forward until the wand clicks and
locks. Plug the charger into the charging port on the
handheld vacuum.
s h a r kc l e a n . c o m
IN HANDHELD VACUUM
If your handheld vacuum's battery is non-removable,
press the Wand Release button to detach the
handheld vacuum. Plug the charger into the charging
port on the handheld vacuum.
OUT OF THE VACUUM
If battery is removable, press and hold the Battery
Release Button, then slide out the battery. Plug the
charger into the charging port on the battery. To
reinstall the battery, slide it into the slot in the back
of the handheld vacuum.
OFF
Slide switch to the bottom to turn off power.
To begin vacuuming in Standard Mode, slide switch
to the desired setting.
CARPET SETTING
Carpet
The brushrolls spin faster to pick up debris below
the surface of your carpets.
SETTINGS
HARD FLOOR SETTING
Hard Floor/Small Area Rugs
The brushrolls spin slowly to clean bare floors and
small area rugs.
BOOST MODE
For an added boost in power, pull the Trigger
on the handheld vacuum. Release it to return to
normal power.
sharkclean.com