Step 2: Install Drinking Water Faucet; Step 3: Install Drain Saddle - Ispring RCS5T Installation Instructions & Operating Manual

Step 2: Install Drinking Water Faucet

2.1 If your kitchen sink does not have an existing 1/2" hole, you will have to drill one. (Refer to
How to Drill a Hole in Sink or Counter-top.) Wipe clean and dry the area. (Contact us for a
larger front plate and washer if the hole is too big to cover.)
2.2 Remove the blue protection film from the front plate, slip it onto the faucet thread, and slip
on the black rubber washer. Insert the faucet thread portion into the hole. Optional plumber
glue or sealer could be used.
2.3 Under the sink, tighten the back rubber washer, lock washer with nut.
2.4 (Refer to How to use compression fitting.) Slip the compression fitting nut and collar onto
the tubing, push the insert into the tubing, insert it into the faucet end, and tighten up the nut.
Pull on the tubing to check if it is secure.

Step 3: Install Drain Saddle

3.1 Choose a spot on the drain pipe that is convenient for installing the drain saddle and tubing.
A horizontal pipe is recommended to minimize the dripping sound.
3.2 Drill a 1/4" hole on the drain pipe; paste the black sticky pad around the hole.
3.3 Cut off the 1/4" tubing end a bit to form a 45-degree angle. Slip the plastic nut and front
plate onto the tubing. Insert the tubing into the 1/4" hole in the drain pipe, install the back
plate and tighten two screws with hex nuts while the tubing remains in the hole.
3.4 Tighten the nut on the Drain Saddle by hand. Pull on the tubing to check if it is secure.
Page 9 www.123filter.com | (678) 261-7611 | support@123filter.com