Solid State Logic SSL UC1 User Manual page 41

Hide thumbs Also See for SSL UC1:
Table of Contents

Advertisement

General Safety
ATTENTION! The desktop power supply must always be earthed. Refer to the User Guide for further details.
CAUTION! No user-serviceable parts inside. In the event of damage to the unit or power supply contact Solid
State Logic. Service or repair must be done by qualified service personnel only.
CE Certification
UC1 is CE compliant. Note that any cables supplied with SSL equipment may be fitted with ferrite rings at each
end. This is to comply with the current regulations and these ferrites should not be removed.
FCC Certification
Do not modify this unit! The product, when installed as indicated in the instructions contained in the installation manual, meets
FCC requirements.
Important: This product satisfies FCC regulations when high quality shielded cables are used to connect with other equipment.
Failure to use high quality shielded cables or to follow the installation instructions may cause magnetic interference with
appliances such as radios and televisions and will void your FCC authorisation to use this product in the USA.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encourage to try to correct the interference by one
or more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance
This Class B digital apparatus complies with Canadian ICES - 003.
RoHS Notice
Solid State Logic complies with and this product conforms to European Union's Directive 2011/65/EU on Restrictions of Hazardous
Substances (RoHS) as well as the following sections of California law which refer to RoHS, namely sections 25214.10, 25214.10.2,
and 58012, Health and Safety Code; Section 42475.2, Public Resources Code.
SSL UC1 User Guide
Safety Notices
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents