Comlog - Fortinet FortiGate-7000E Series System Manual

Hide thumbs Also See for FortiGate-7000E Series:
Table of Contents

Advertisement

FortiGate-7060E System Management Modules
Use the following command to power on the FIM in slot 2 (IPMI address 0x84):
fru activate 0x84
Use the following IPMI command to reset the module SMC to reboot the FPM in slot 3:
sudo ipmitool -I lanplus -H 10.160.19.30 -k gkey -U admin -P admin -t 0x86 mc reset warm
Use the following IPMI command to power off the FPM in slot 4:
sudo ipmitool -I lanplus -H 10.160.19.30 -k gkey -U admin -P admin -t 0x88 picmg deactivate 0
Use the following IPMI command to power on the FIM in slot 2 (IPMI address 0x84):
sudo ipmitool -I lanplus -H 10.160.19.30 -k gkey -U admin -P admin -t 0x84 picmg activate 0

Comlog

All FIM and FPM SMCs include a comlog system for writing and saving console log messages. When enabled, the
comlog saves log messages in a local comlog file. Log messages include all local host console messages including
BIOS boot up messages. In the comlog these messages include the following headers:
Header
\n--- COMLOG SYSTEM BOOT: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG DISABLED: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG ENABLED: YYYY/MM/DD hh:mm:ss ---\n
\n--- COMLOG TIME: YYYY/MM/DD hh:mm:ss ---\n
The following comlog-related CLI commands are available:
Description
Display comlog information.
Available on the passive
module.
Display a module's comlog.
Available on the passive
module.
Clear a module's comlog. Either
by resetting the a comlog start
location in flash (reset_loc) or
erasing all of the flash storage
FortiGate-7060E 6.4.2 System Guide
SMC CLI Commands
comlog getinfo
Status
Disabled
COM
Speed 9600
Storage Size
0x00400000
Log Start
0x00000000
Log End
0x00000C37
Log Size
3127 Bytes
comlog getinfo <slot>
comlog print <slot>
comlog clear [reset_loc]
[chip_erase]
Cause
The module is starting up after being powered on
or reset.
Logging is disabled.
Logging is enabled
This message is written every hour when the
module is powered on and logging is enabled.
IPMI commands
fortinetoem comlog getinfo
fortinetoem comlog print
fortinetoem comlog clear
Fortinet Technologies Inc.
56

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fortigate-7060e

Table of Contents