Power Cord Clamps; Mounting The Fortigate-7060E Chassis In A Four-Post Rack - Fortinet FortiGate-7000E Series System Manual

FortiGate-7060E hardware assembly and rack mounting

Power cord clamps

You can also install power cord clamps into the back of the chassis beside each PSU. Install the clamps by inserting
them into the holes adjacent each supply at the back of the chassis. Use the clamps to secure the AC power cords so
they are not accidentally disconnected.

Mounting the FortiGate-7060E chassis in a four-post rack

The FortiGate-7060E package includes a set of extendable brackets that you can use to mount the chassis in a 4-post
rack. Install the brackets to create a 4-post rack mount tray that the chassis will slide on to. Attach each side of the tray
to the 4-post rack using the front and back brackets as shown below. Make sure you install the tray with enough space
above it for the chassis. The length of the tray sides adjusts to match your rack. Once the 4-post rack mount tray has
been installed, slide the chassis onto the tray and secure it to the rack mount tray as shown in the diagram.
Attach the Left
Tray to the Left
Rack Posts
Rack Mount
Screws not
provided
FortiGate-7060E 6.4.2 System Guide
Rack Mount
Screws not
provided
Attach the Right
Tray to the Right
Rack Posts
Secure the Chassis
to the Rack Mount Tray
M4x8 pan-head screw
with M4 washer (both sides of chassis)
Fortinet Technologies Inc.
Rack Mount
Screws not
provided
26