Graco TapeLazer HP Automatic Operation, Parts page 13

11. Remove tamping roller and using a 1/4
in. Allen wrench remove bolt on one end
of the hex shaft. Loosen set screws in
rollers to remove or adjust them to the
necessary width and location to match
the tape.
NOTE: Removed rollers can be stored on the
vertical posts located in front of the
handlebars.
3A8108A
Setup/Startup
12. Tighten set screws on all roller segments
once in place and re-install bolt on the
end of hex shaft.
13. Re-install tamping roller, plate and bolts.
Tighten bolts with 1/4 in. Allen wrench.
.
13