Graco TapeLazer HP Automatic Operation, Parts page 12

Setup/Startup
4. Rotate pivot bar away from applicator
roller.
5. Using a 1/4 in. Allen wrench, remove the
three bolts holding the end plate on the
applicator roller.
NOTE: It is only necessary to remove the end
plate on one side of the carriage to remove
the applicator roller.
6. Remove applicator roller and using a 1/4
in. Allen wrench remove the bolt on one
end of the hex shaft. Loosen set screws
in rollers to remove or adjust them to the
necessary width and location to match
the tape.
NOTE: Removed rollers can be stored on the
vertical posts located in front of the
handlebars.
12
7. Tighten set screws on roller segments
once in place and re-install bolt on end of
hex shaft.
8. Re-install applicator roller, plate and
bolts. Tighten bolts with 1/4 in. Allen
wrench.
9. Rotate the pivot bar back into place and
replace the bolts on both sides of the
carriage.
10. Using a 1/4 in. Allen wrench, remove the
three bolts holding the end plate on the
tamping roller.
3A8108A