AJA D10C2 User Manual

AJA D10C2 User Manual

10-bit serial digital to composite/component converter

Advertisement

D10C2 10-bit
Serial Digital to Composite/
Component Converter
User Manual
P/N 101640-00
October 25, 2003

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D10C2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AJA D10C2

  • Page 1 D10C2 10-bit Serial Digital to Composite/ Component Converter User Manual P/N 101640-00 October 25, 2003...
  • Page 2: Fcc Emission Information

    AJA Video, with shipping charges prepaid. AJA Video shall pay for the return of the product to the Customer if the shipment is to a location within the country in which the AJA Video service center is located.
  • Page 3: Block Diagram

    NTSC (525 line input), PAL (625 line input) or component as configured by the dip switches. The D10C2 encodes the full dynamic range of input component video—values below black and above white are not clipped. In the NTSC mode, the 7.5 IRE pedestal can be disabled by dip switch selection.
  • Page 4 SDI Loop Output BNCs Output 1 Configuration Determined by SDI Loop DIP switch on Output 2 other side of Converter Use the top + 5VDC BNC when the Power Input device being fed requires a separate sync signal D10C2, Side View...
  • Page 5: User Controls

    AJA D10C2 10-bit Serial Digital to Composite/Component Converter User Manual — User Controls User Controls The user interface for the D10C2 is a 4-switch DIP accessible through a cut-out in the bottom of the unit. Use the DIP switches to configure outputs, pedestal, and blanking.
  • Page 6 Switch 4 Configure Blanking For Component Output BNCs (3) WIDE Blanking: NARROW (NAR) Blanking: Vertical— Vertical— Line numbers indicate where video Line numbers indicate where video starts starts) line 13, field 1; line 12, field 2 (525 line) line 20, field 1; line 20, field 2 (525 line) line 10, field 1;...
  • Page 7: Installation

    AJA D10C2 10-bit Serial Digital to Composite/Component Converter User Manual — Installation Installation Typically, D10C2 installation consists of the following: 1. disconnect +5VDC from the convertor 2. configure the DIP switch for the desired equipment configuration and video formats 3. connect video equipment to the convertor BNCs 4.

Table of Contents