Ethernet Interfaces X120 And X130 - Siemens SIMOTION D45 Series Manual

Interfaces

3.3 Ethernet interfaces X120 and X130

3.3 Ethernet interfaces X120 and X130
Interfaces for connection to Industrial Ethernet.
Industrial Ethernet is a communication network with a transmission rate of 10/100 Mbit/s.
SIMOTION D4x5 offers the following functions via Ethernet interfaces:
• Communication with STEP 7 and SIMOTION SCOUT
• Communication between SIMOTION and SIMATIC NET OPC
• Communication by means of SIMOTION OPC XML-DA (separate license required).
For additional information on the software packages, refer to the
System, PM 10 Catalog
Position of connectors
The following figure shows the mounting position and designation of the Ethernet connectors
on the module.
Figure 3-2
36
With STEP 7 V5.2 and lower, the "SIMATIC NET SOFTNET-PG (Protocol TPC/IP RFC
1006)" software must be installed on the PG/PC. With STEP 7 V5.3 and higher, additional
software is not needed.
The "SIMATIC NET SOFTNET-S7 (S7-OPC server)" software must be installed on the
PG/PC for this function.
Note
SOFTNET-S7 is a superset of SOFTNET-PG, i.e., SOFTNET-S7 contains Protocol
TPC/IP RFC 1006, as well.
(see list of references for order number).
B
8
1
A
Ethernet interface
SIMOTION Motion Control
Manual, 03/2007 Edition
D4x5