Advertisement
Changing the bungee cord
Step 1. Remove the Perspex cover
Step 5. Remove all excess bungee cord
from the belt bungee pulley as shown
right. This will allow you to see clearly
where the bungee cord fits through the
belt/bungee pulley.
.
Step 2. Remove the side inspection plate.
Step 6. Start to rewrap the belt toward the front of the machine by
winding the belt onto the belt/bungee pulley. The goal is to match the
bungee position on the belt bungee pulley and the hole at the top of
the sprocket. This will allow you to pull the bungee cord through the
sprocket hole as shown right without having to pull the machine apart.
Do not under any circumstances
place hands on or inside chain and
sprockets! Use the inspection plate
area to work only.
Step 3. Undo the bungee cord from
the attachment point.
Warning
Step 4
Step 6
Step 4. Pull the rower handle approx half a
rowing stroke toward the rear of the ma-
chine, while at the same time watching for
the upper sprocket hole to appear as shown
above.
Remove the bungee cord.
Advertisement
