First Degree Fitness Fluid FR S-350 Owner's Manual page 15

Troubleshooting Guide
Fault
Water changes color or becomes cloudy.
Rower belt slipping off belt/ bungee pulley.
Front of rower lifts slightly during vigorous
rowing.
Excessive frame flex during hard rowing.
Computer screen illuminates, but does not
register when rowing.
Excessive Chain noise.
The S-350 computer does not illuminate after
battery installation.
Probable Cause
Rower is in direct sunlight or has not had
water treatment.
Bungee not under enough tension.
Lower rear frame leveler too high.
Lower rear frame leveler too low.
Loose or failed connection.
Loose or dry chain.
Batteries installed incorrectly or need re-
placing.
Solution
Change rower location to reduce direct expo-
sure to sunlight. Add water treatment and blue
dye or change tank water as directed in the
water treatment section of this manual.
Tighten bungee cord following the instructions
in the Replacing the bungee/shock cord section
of this manual.
Refer to the Fine Tuning section of this manual
Refer to the Fine Tuning section of this manual.
Check that the computer lead is connected
properly. If it is connected then contact your
local service center.
Loosen tank bolts slightly and then use the
tank tensioning bolt to tighten chain. Lubricate
with supplied 20-weight oil. Use drop cloth un-
der frame. Refer to the Maintenance page,
chain tension and lubrication for details.
Reinstall batteries in correct position and try
again. If the LCD screen fails to illuminate, try
rotating the batteries slightly in the computer. If
this fails, contact your local service center.