Fuel Cell Warnings; Charger And Battery Warnings - Kyocera TJEP ST-15/50 GAS Safety And Operation Instructions

2g gas nailer
Hide thumbs Also See for TJEP ST-15/50 GAS:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 62
• Use only accessories made or recommended by
the tool manufacturer, or accessories that perform
equivalently to those recommended by Kyocera
Unimerco Fastening.
• Load the fastener after loading the battery and fuel
cell to prevent unexpected fastener firing.
• Disconnect the battery and fuel cell if the fastener
jams in the gas tool. While removing a jammed
fastener, the nailer may be accidentally activated if
the battery and/or fuel cell is plugged in.
• Use caution while removing a jammed fastener.
The mechanism may be under compression and
the fastener may be forcefully discharged while
attempting to free a jammed condition.
• Remove the fuel cell and battery when
· Not in use;
· Performing any maintenance or repairs;
· Clearing a jam;
· Elevating, lowering or otherwise moving the
gas tool to a new location;
· The gas tool is outside of the operator's super-
vision or control
· Removing fasteners from the magazine.
• Children shall not play with the appliance. Clean-
ing and user maintenance shall not be made by
children.
• Maintain the gas tool with care. If damaged, have it
repaired before use. Please refer to the mainte-
nance instructions for detailed information on the
proper maintenance of the gas tool.
• Please keep the gas tool in clean condition, wipe
off grease and/or oil after work. Do not use any
solvent based cleaner to clean the gas tool. It is
possible that the solvent will deteriorate the rubber
and/or plastic components on the gas tool. Greasy
handle and tool body can cause accidental drop of
the gas tool and injury to nearby person.
• Have your gas tool serviced by a qualified repair
person using only parts that are supplied or
recommended by Kyocera Unimerco Fastening.
This will ensure that the safety of the gas tool is
maintained.
• Use only lubricants recommended by Kyocera
Unimerco Fastening / your local TJEP dealer.

Fuel cell warnings

• Use only the fuel cell recommended by Kyocera
Unimerco Fastening. Read the Material Safety
Data Sheet to understand more of your fuel cell
contents and be aware of transport regulations.
• The fuel cell is a high pressure liquefied gas
container. The content of the fuel cell is extremely
flammable, keep it away from sparks, fire, high
temperatures and explosive environment. Do not
puncture the fuel cell or attempt to open the con-
tainer. The fuel cell contains flammable gas even if
it appears empty. Follow the recycle instruction on
the fuel cell.
• Recycle the empty fuel cell according to the local
law. Do not attempt to recharge the fuel cell or
incinerate the empty fuel cell.
• Do not expose the fuel cell or tools loaded with
fuel cell under direct sun light. Prevent to put the
fuel cells at temperatures higher than 49°C(120°F).
Overheating the fuel cell can result in explosion or
fire.
• Handle fuel cells carefully and check for damages.
Damaged fuel cells can explode and cause injury.

Charger and battery warnings

• Recharge the batteries only with the charger
specified by Kyocera Unimerco Fastening. A
charger that is suitable for one type of battery pack
may create a risk of fire when used with another
battery pack.
• The charger plug must match the outlet. Never
modify the plug in any way. Unmodified plugs and
matching outlets will reduce risk of electric shock
• Avoid body contact with earthed or grounded
surfaces such as pipes, radiators and refrigerators
when working with electrical equipment. There is
an increased risk of electric shock if your body is
earthed or grounded.
• Do not expose the battery or charger to rain, snow
or wet conditions and do not immerse the battery
or charger into water or other fluids, as it will
increase the risk of electric shock.
• Do not abuse the cord. Never use the cord for car-
rying, pulling or unplugging the charger. Keep cord
away from heat, oil, sharp edges or moving parts.
Do not use the battery charger if the cord is dam-
aged or the battery charger is defect. Damaged or
entangled cords increase the risk of electric shock.
English
63

Advertisement

Table of Contents
loading

Table of Contents