Table of Contents
Advertisement
Device Management
This section describes how to connect to and manage the device.
3.1
Connecting to the Device
The following describes the various methods for accessing the RUGGEDCOM M969
console and Web interfaces on the device. For more detailed instructions, refer to the
RUGGEDCOM M969 User Guide for the RUGGEDCOM M969.
RS-232 Console Port
Connect a PC or terminal directly to the RS-232 console port to access the boot-
time control and RUGGEDCOM M969 interfaces. The console port provides access to
RUGGEDCOM M969's console and Web interfaces.
IMPORTANT
The console port is intended to be used only as a temporary connection during initial
configuration or troubleshooting.
Connection to the console port is made using an M12-to-DB9 console cable. The
following is the pin-out for the console port:
6
Figure 3.1
Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM M969 console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM M969 is
https://192.168.0.1.
RUGGEDCOM M969
Installation Manual, 01/2021, C79000-G8976-1039-03
8
1
7
2
3
5
4
M12 Console Port Pin
Configuration
Pin
Name
1
Reserved (Do Not Connect)
2
RX
3
TX
4
Reserved (Do Not Connect)
5
GND
6
Reserved (Do Not Connect)
7
Reserved (Do Not Connect)
8
Reserved (Do Not Connect)
3
Description
Receive Data
(from DTE)
Transmit Data
(from DTE)
Common Ground
17
Advertisement
Table of Contents
