Printer Kit Installation (Act1234-Pik); Refrigerant Identifier Kit Installation (Act1234-Rik) - Bosch ACS 653 Repair Instruction

ACS 653, ACS 663 Service Manual

Printer kit installation (ACT1234-PIK)

WARNING: Disconnect the unit from
the power source before beginning
service work. Incorrect use or
connections can cause electrical
shock.
For the printer installation follow instructions
hereby:
1. Switch off the machine.
2. Remove the printer protective cover.
3. Remove the cap (6) and the visible screw
from the hole.
4
3
3
5
Figure 1-11. Print installation
Robert Bosch GmbH
6
1
2
21
Introduction
4. Remove the control panel (2) of the unit to
have access inside.
5. Connect the RS232 cable (4) and the power
supply cable (5) to the suitable connectors
on the printer.
6. Fit the printer (1) and fix it by means of the
proper fixing tabs (3).
7. Connect the RS232 cable (4) to the P18
connector of the control board.
8. Connect the power supply cable (5) to the
P15 connector of the control board.
9. Re-fix the control panel (2).
10. Screw back the screw and place the cap (6).
11. Connect again the machine to the power
supply system and switch it on.
12. The printer is ready to be used.
Refrigerant Identifier kit installation
(ACT1234-RIK)
WARNING: Disconnect the unit from
the power source before beginning
service work. Incorrect use or
connections can cause electrical
shock.
WARNING: Wear safety goggles
when working with refrigerants.
Refrigerants can cause eye injury.
WARNING: Use extreme caution
w h e n d i s c o n n e c t i n g h o s e s .
Pressurized refrigerant may be
present in hoses. Point hoses away
from you and anyone nearby.
For the refrigerant identifier kit installation follow
instructions hereby:
1. Clear service hoses and remove them.
2. Switch off the machine.
3. Remove the 3 screws (1) either from left
and right side of the machine and the
2 screws (2) underneath the frontal panel
(see Figure 1-12).
4. Remove the front plastic cover.
5. Open the service rear door.
6. Remove the rear cover (above the service
door) by pushing it up and extract it by
pulling it out.
SP00D00624 2021-04-08