ACS 653, ACS 663 Service Manual
COMPONENT APPLICATION CHARTS
NOTES FOR COMPONENT APPLICATION CHARTS
1. Tank Fill Process: The output state of the Recover solenoid is controlled to maintain 2.4 bar
(35 psi) in the accumulator.
2. Recover Process: The output state of the recover solenoid is controlled to maintain 0.55 bar
(8 psi) to 4.27 bar (62 psi) max. in the accumulator. The output state of the oil return solenoid
is initially activated for three seconds, and reactivated every 10 minutes thereafter depending
on the length of the recovery process.
3. Deep Recover Process: The output state of the oil return and recycle solenoids are controlled
to maintain 0 to 207 mbar (3 psi) in the accumulator.
4. Vacuum Process: The unit may purge air in the background of the vacuum process.
5. Recycle/Power Charge Process: If the unit does not complete a full charge, the compressor
and recycle solenoid, cycle to build tank pressure.
Manifold Component Application Chart, ACS 653, ACS 663-RI and ACS 663
Function
Component
Air Purge solenoid (S1)
Oil Inject 1 (PAG)
solenoid (S2)
Oil Drain solenoid (S3)
Low-Side Inlet solenoid (S4)
High-Side Inlet solenoid (S5) ON
High-Side Charge
solenoid (S6)
Low-Side Charge
solenoid (S7)
Recycle solenoid (S8)
Vacuum solenoid (S9)
Recover solenoid (S11)
Deep Recover solenoid (S12)
Oil Return solenoid (S13)
Oil inject 2 (POE)
solenoid (S14)
Dye solenoid (S15)
Identifier solenoid (S17)
(for ACS 663-RI only)
Tank liquid solenoid (S22)
Pump
Compressor
Fan
Legend
Robert Bosch GmbH
ON
ON ON
ON ON
ON
I
I
ON
I
I
I
I
ON
ON
ON
ON
ON ON
ON
ON
ON
ON ON ON ON
ON
ON
Plumbing and Mechanical
I
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON ON ON ON ON ON
I
97
I
ON
I
ON
ON
I
I
ON
I
I
I
ON
I
ON
ON
ON
ON ON
ON
ON
ON
ON
ON
ON
ON
ON Intermittently
SP00D00624
2021-04-08
I
I