Installing the Yale iM1 Network Module
IMPORTANT: Batteries must be removed prior to
removing and/or inserting the network module:
•
Remove battery cover and batteries.
•
Remove and/or insert Network Module.
•
Reinstall batteries and battery cover.
Enrolling the iM1 Network Module:
The Yale iM1 Network Module must be used with a Yale Assure Lock or Yale nexTouch Lock and
cannot be used in conjunction with any other Yale Network Module.
To Enroll the Module:
•
Enter the 4-8 digit Master PIN code followed by the
•
Press the
•
Press the
Connecting the Yale Secure App with the Yale iM1 Network Module
1. After following steps listed on other side of page for enrolling module, download the Yale Secure
app from App Store .
®
2. Ensure Bluetooth is enabled on your iPhone , iPad or iPod touch , and that you're within a
foot of your Yale lock.
3. Open the Yale Secure app and agree to allow app to access your Home Data.
4. If you do not have a home already created, create a new home when prompted. Tap + to add a
new Yale Lock.
5. The App will search for your Yale Lock. Be sure that you are within close proximity (less than
two feet or so). When "Yale Lock" appears, tap to add.
*If lock does not appear, enter your Master Pin Code on lock keypad, tap gear, tap 7, tap gear,
tap 1 and then tap gear.
6. Scan your Accessory Setup Code; shown below, or manually enter within the app.
®
Installation and Programming Instructions
key followed by the
key followed by the
®
Accessory Setup Code
Yale iM1 Network Module
®
key.
key.
key.
®
®
®
P/N AYR-202-iM1-INSTAL-FUL Rev E
Need help?
Do you have a question about the real Living iM1 and is the answer not in the manual?
Questions and answers