Table of Contents
Advertisement
-
position the tester,
-
then successively control, right and left beam. The tester tells you the headlamp to be controlled,
the high beam hot spot position with arrows and light intensity in lux or kcd.
High beam Right
Fog light
As did previously, you have to:
-
define the fog light height to be controlled
-
position the tester ( « Positioning assistance » is not available with fog light function)
-
then successively control, right and left beam. The tester tells you the headlamp to be controlled
and cut-off measured in % and light intensity in lux or kcd as well
Right Fog light
Test result
Vehicle inspection is now complete.
You can visualize your measurement results by pressing on arrow
GIEGNET mode:
To send the measurements, press key
In case there is a problem in the transmission of the measurements, you can access to the print-out mode
by pressing on arrow
printer.
Print-out mode:
To send your results, switch on the printer and press key
30/06/16
HR
Hot spot too much right and down
HR >>OK<<
Hot spot is correctly positioning
RF -1,2% 025kcd
Cut-off
End of control
.
. Thus, by validating on
125kcd
125kcd
Light intensity
.
you launch the print-out of your results on a
.
12
Light intensity
Rev A
Advertisement
Table of Contents
