Table of Contents
Advertisement
2.3 Main functions
5 main modes are available when the tester is on:
Menu 1: Vehicle Inspection
The menu Vehicle Inspection enable to carry out dipped headlamps cut-off control (and fog lights as an
option). Test results could be forwarded to a PC through the GIEGNET protocol. It is also possible to
print-out the results.
Menu 2: Dipped headlamps adjustment
This function enables to carry out dipped headlamps adjustment. It enables a vertical adjustment
complying with the cut-off wished by the operator. It enables a lateral adjustment at 0% only on
CAP2500. Furthermore, the tester gives the light intensity and dazzling default provided by the dipped
headlamp.
Menu 3: High beam adjustment
High beam adjustment enables to adjust these lamps at 0%, both lateral and vertical. The operator is
guided to carry out his adjustment thanks to direction arrows. Furthermore, the light intensity of the high
beam is displayed on the screen.
Menu 4: Fog light adjustment
This mode displays the cut-off measured on fog lights so that the operator can make an adjustment with
an optimal cut-off.
Menu 5: Configuration
This menu gives access to several sub-menus enabling to parameter the various functionalities of the
CAP2500 and CAP2300, such as the print-out mode choice, the date and time setting, the contrast
adjustment, etc.
2.4 Tester power supply
CAP2300
The CAP2300 is provided with R14 C-type non-rechargeable batteries.
Remark: Deactivation of backlight enables to multiply by 3 the tester autonomy.
ATTENTION: Do not try to recharge the CAP2300 batteries.
30/06/16
4
Rev A
Advertisement
Table of Contents
