Table of Contents
Advertisement
CAP2500
The CAP2500 is provided with R14 C-type rechargeable batteries.
Remark:
Deactivation of backlight enables to multiply by 3 the tester autonomy.
When the batteries are empty, the battery light starts to blink. You must then charge them again. Connect
on the rear plug of the tester the 9V charger supplied by CAPELEC.
Battery charge is shown through continuous lighting of the battery light. When the light is off, the
batteries are charged and then you can disconnect the charger.
Remark about the charger:
Disconnection device is the adapter block. Therefore, it must remain accessible.
You must not use in any case another charger than the one supplied by Capelec.
CAP2500 & CAP2300
Remark on the batteries:
Battery replacement must be done with original parts.
Battery rejection :
Get rid of the batteries according to laws and regulations into effect in your own country. Do not throw
used batteries in your dust bin : in most of the countries, it is forbidden by law to incinerate them, to bury
them or to throw them away in rubbish dumps.
Please contact local authorities for further information on measures taken in your country to collect,
recycle and destroy used batteries.
30/06/16
Rev A
5
Advertisement
Table of Contents
