Table of Contents
Advertisement
ATTENTION: During this operation, you must be sure that the front side of the tester is not
exposed to external light interference (sun, spot light), which could change the positioning.
Visual positioning for CAP2300 or CAP2500:
If the positioning assistance is not available on your tester, manual positioning is done by
placing face-to-face the lens centre and the headlamp centre as well.
1- First, position laterally the optical head in front of the headlamp
2- Measure the headlamp centre height and position the lens centre at this level.
30/06/16
Rev A
10
Advertisement
Table of Contents
