High Beam Adjustment Function; Fog Light Adjustment Function - Capelec CAP2500 User Manual

5.2 High beam adjustment function

Positioning
First of all, you must position the headlight tester in the front of the headlamp to be adjusted (See chapter
"Headlight tester positioning").
Remark : If the « Positioning assistance » is available, the tester will tell you how to move the optical
head so that to reach the optimal position for the control.
Lateral and vertical hot spot adjustment
Important When you adjust dipped headlights or high beam in the same optics, the priority must be given
to the dipped headlights adjustment : an offset may exist due to the position of the filaments in the bulb.
This function allows the operator to make both lateral and vertical adjustment of high beam. First of all,
you must carry out positioning of the CAP2500 in front of the headlamp to be adjusted (See chapter IV).
Adjust laterally and then vertically the headlamp by following the indications of the arrows on the screen.
Hot spot must go left Hot spot must go up
When « Ok » is displayed on the screen, the headlamp is correctly adjusted.
>>OK<<
Light intensity diagnostics
125kcd
Light intensity in kcd or Lux

5.3 Fog light adjustment function

Positioning
First of all, you must position the headlight tester in the front of the headlamp to be adjusted (See chapter
"Headlight tester positioning").
Remark:
The « Positioning assistance » is not available with fog light function.
30/06/16 Rev A
14