Changing The Color Of The Leds; Changing The Brightness Of The Leds; Changing The Display Mode Of The Leds - Garmin Fusion Wireless RGB LED Remote Control Instructions Manual

Changing the Color of the LEDs

1 If you installed more than one remote control receiver, press the group number to select the receiver to
control (Pairing Additional Receivers to the Remote, page
2 If necessary, turn on the LEDs for the speakers you want to change.
3 Select an option:
• Touch the color wheel to select a new color, and slide your finger to fine-tune it.
• Hold to change the LED color to white.
NOTE: If you installed more than one remote control receiver, you can hold the group number to change the
LED color for that group to white.

Changing the Brightness of the LEDs

1 If you installed more than one receiver, press the group number to select the receiver to control
Additional Receivers to the Remote, page
2 If necessary, turn on the LEDs for the speakers you want to change.
3 Select an option:
• To increase the LED brightness, press
• To decrease the LED brightness, press

Changing the Display Mode of the LEDs

You can cycle through a pre-defined set of LED flashing, breathing, or color-changing
Options, page 5.
1 If you installed more than one remote control receiver, press the group number to select the receiver to
control (Pairing Additional Receivers to the Remote, page
2 If necessary, turn on the LEDs for the speakers you want to change.
3 Select an option:
• To select the next mode in the sequence, press
• To select the previous mode in the sequence, press
4 Touch a color on the color wheel to stop the display mode and return to a solid color.
Display Mode Options
You can select among 12 different color and transition patterns. When you reach the end or beginning of the
cycle of display modes by pressing
Display mode 1
Display mode 2
Display mode 3
Display mode 4
Display mode 5
Display mode 6
Display mode 7
Display mode 8
Display mode 9
Display mode 10
Display mode 11
Display mode 12
Wireless RGB LED Remote Control Instructions
6).
above
below
or , the cycle loops to the beginning or end.
RGB jumping change
RGB fading change
7-color jumping change
7-color flashing change
7-color fading change
7-color gradient change
White only, fades in and out
Red only, fades in and out, then flashes 3 times
Green only, fades in and out, then flashes 3 times
Blue only, fades in and out, then flashes 3 times
White only, fades in and out, then flashes 3 times
Automatically cycle through the previous 11 display modes
6).
.
.
6).
above (Display Mode Options, page
below .
(Pairing
effectsDisplay Mode
5).
5