Note: Operators may use STC SA0487SE qualification of the GRC/GRT 0 as a basis for showing compliance with 4 CFR Part 9.2. Note: This device has been approved for use in the USA and Canada only. Note: The USB port is for factory use only. introduction The GRC 0 is a remote control for the XM radio function of the GDL 69A.
Battery installation Battery Cover The GRC 0 requires two AA batteries (included). Remove the battery lid, located in the back of the unit, by pressing down and pulling out the tab. Alkaline batteries are recommended, but NiCd or NiMH batteries may be used.
Page Navigation Press the t or u key to move through the pages: Channels, Active Channel, and Categories. Press the p or q key to move up and down through the list of the current function to highlight the desired item. active Channel Page Press the t or u key to display the Active channel information.
Category Page Categories of channels, such as Jazz, Rock, Sports, or News, can be selected to list the available channels for a type of music or other contents. Category List To select a Category . Press the t or u key to display the Category list. 2.
adjusting the LCD Contrast If the display is difficult to read, you may adjust the LCD Contrast. To adjust the LCD Contrast . Press the MeNu key. 2. Press the p or q key to highlight the Contrast menu selection. 3.
Previous Channel Pressing the PReV key will toggle between the current channel and the previously selected channel. Preset Channels The PSet (Preset) key allows you to store up to 5 favorite channels to a selected Preset number. The presets are stored in the GDL 69A so they can be accessed from the cockpit display.
Setting Volume The + and - keys at the bottom of the unit allow you to set the volume for the system. The volume +, volume –, and mute keys may not function in all installations since the volume may be configured to be adjusted individually at each headset.
Page 11
Messages Description Message GRT 0 not found The GRC 0 has not estab- lished communication with the GRT 0 GDL 69A not found The GRT 0 has not estab- lished communication with the GDL 69A GDL 69A connection The GRT 0 has lost communi- lost cation with the GDL 69A GRT 0 connection lost...
Need help?
Do you have a question about the GRC 10 Remote Control and is the answer not in the manual?
Questions and answers