Garmin Fusion Wireless RGB LED Remote Control Instructions Manual

Wireless RGB LED Remote Control Instructions

Important Safety Information

Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor
product performance.
See the Important Safety and Product Information guide in the stereo box for product warnings and other
important information.
This device must be installed according to these instructions.
Disconnect the vessel's power supply before beginning to install this product.
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
You must read all installation instructions before beginning the installation. If you experience difficulty during
the installation, contact Fusion

What's in the Box?

• Wireless RGB LED remote control
• Remote control receiver
• Remote control cradle
• 7.5 A in-line fuse
• Important safety and product information document

Supplies and Tools Needed

• 2-conductor 22 AWG (0.33 mm
• 4-conductor 22 AWG (0.33 mm
receiver to the RGB LED speakers
• Cable ties or adhesive for mounting the receiver
• 4 gauge (3 mm) countersunk stainless-steel screws for mounting the remote cradle (optional)
• 3 mm flat screwdriver
• Wire cutters
• Drill and drill bits for mounting the remote cradle (optional)
July 2021
WARNING
CAUTION
NOTICE
® Product Support.
2
) wire to connect the remote control receiver to the power source
2
) wire (or equivalent combination of 2-conductor wire) to connect the
GUID-EE2CF989-3621-4468-952F-F2FF10257458 v2