Page 1
Inquiry Network status with SMS! Power Failure alarm by free phone call or SMS! Interval Report Status to Your Mobile Phone by SMS! GSM/GPRS/3G/4G/Cloud Alarm Network Fault Monitoring User Manual Ver 1. 1 RTU5028E Date Issued: 2020-01-07 All rights reserved by King Pigeon Hi-Tech.
We recommend that the advice of a registered electrician be sought before any Installation work commences. King Pigeon Hi-Tech.Co., Ltd, its employees and distributors, accept no liability for any loss or damage including consequential damage due to reliance on any material contained in this handbook.
Monitor Alarm unit X 1; Antenna X 1; AC/DC adaptor( DC12V 1.5A ) X1 ;User manual X 1. Note: The package does not include any SIM card. Optional: DIN 35mm Standard DIN rail fixed Bracket Page 3 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Flicks quickly means data transmission. Power indicator: LED ON when connect power;otherwise,it is OFF Alarm Indicator:Alarm will ON ;Normally is OFF; Relay Indicator: Relay open will ON;Relay close will OFF. 6.2 Interface Instruction Page 5 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 6
1.upgrade,press it and switch on the device will enter upgrade state;2.reset,press it then hold on 3 seconds in the state of power on will reset ) and card slot as below: Switch OFF Switch ON Page 6 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Connection : Only the password is correct can connect successfully, and can be configured after connection. Read: Read the current configuration of the device and read it before editing the parameters. Save: Write edited parameters to the device. Page 7 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 8
Press * or # to stop Dial:: Untick ,it will not continue to dial if someone answer;Tick it,Alarm dialling will dial continue if not press the button,until press the * or # button. Modify Password: Can modify the device Password(4 digits, Default is: 1234). Page 8 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 9
Alarm Recovery: Tick it stands for enable the SMS notification when the alarm recovery to normal value. GPRS Failure: Tick it stands for enable the SMS notification when the GPRS connection failure. Page 9 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 10
Alarm-link Relay: Tick it stands for when the network failure, the alarm link the output relay open for 2 seconds, if the network not recover,it will open for 2 seconds again, if still not recover 5 minutes later,will the last time open for 2 seconds. Page 10 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 11
Server Settings: Server 1 IP/Domain,Server Port: Primary server address,supports 3 protocol: 1) Modbus RTU Protocol: connect to King Pigeon cloud platform. Domain: modbusrtu.kpiiot.com, Port: 4000. 2) Modbus TCP Protocol: connect to King Pigeon cloud platform. Domain: mbtcp.my-m2m.com, Port: 6655. 3) MQTT Protocol: connect to King Pigeon cloud platform. Domain: mqtt.my-m2m.com, Port: 1883.
Page 12
GSM/GPRS/3G/4G/Cloud Network Fault Monitoring Alarm Name, this item used for device ID, provided by cloud. Contact King Pigeon sales if need to connect to King Pigeon cloud server. Login ACK Message: Once set,the server need send message to the device,or device will be offline.
**SMS Commands For Program and Operation the RTU5028E** 1) Setup the RTU5028E SIM Card Number(Max 21 digits) This number is used for automatically adjust the time from GSM Operator. Command Return SMS Example Page 13 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 14
Voltage: Setup y=z,will not alarm.voltage value should be setup at 10 multiples of Low: y,High: z. actual value. Page 14 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 15
9) Setup Interval Report Time The content is same with return SMS of command “PWD+EE”. Command Return SMS PWD+DT+x Setup Report status every xxx hours (xxx=001-999hours, must be 3digits,default 999,stands for disable Page 15 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 16
13) Setup PING Device IP Command Return SMS Example PWD+PINGIP+x=y (x=1~7,stands network device IPx:y 1234PINGIP1=192.168.1.188 1~7,y stands for IP address) to set device 1 IP address as 192.168.1.188. Inquiry PWD+PINGIP+x Delete PWD+PINGIPDEL+x Page 16 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 17
(x=DNS server) Setup Primary DNS Server 1234DNS1=114.114.114.114 To set primary DNS server as 114.114.114.114 PWD+DNS2=x (x=DNS server) Setup Backup DNS Server 1234DNS2=8.8.8.8 To set primary DNS server as 8.8.8.8 Page 17 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 18
22) Setup the Heartbeat Interval Command Return SMS PWD++HT+x Setup Heart Pack Period:x x=0~9999 seconds,default is 60 seconds,0 stands for not upload seconds Inquiry PWD+HTE 23) Setup Device ID Page 18 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Page 19
( Each SMS will include one IMEI Code as Device ID.) 27) Setup Language Reset the unit after changing the language. For the reset operation, please refer to "13. Remotely Resett") Command Return SMS Setup PWD+EN English Page 19 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Actual=Register Value/10 10.2. MQTT Protocol When the device connects to King Pigeon cloud platform with MQTT, the user could use it immediately, don't need to care about the MQTT protocol. If you need to connect to your own server, the following is the protocol for you.
Page 21
"addTime":"2019-01-02 12:34:56", "switcher":"1", //Switch type data, 0 is fault, 1 is normal "flag":"DI7" //Network device 7 identification "addTime":"2019-01-02 12:34:56", "switcher":"1", //Switch type data, 0 is fault, 1 is normal Page 21 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...
Operating Instructions. In no event shall the manufacturer be liable for any alarm system altered by purchasers. The End! Any questions please feel free to contact us . Http://www.4G-RTU.com Page 22 of 22 King Pigeon Hi-Tech. Co., Ltd. Ver 1.0...