Device Connections; Led Behavior - Ubee UBC1329AA00 User Manual

1.5

Device Connections

The following table describes the connections on the rear panel of the
UBC1329AA00.
Label Description
To reset (power cycle) the device, use a pointed object like the end of a paper clip to push
down the reset button. To power cycle the device, hold for less than 5 seconds. To reset to
RESET
factory default settings, hold for more than 5 seconds. The UBC1329AA00 will reset and
reboot. WARNING: Resetting to factory defaults will erase any and all settings you have
configured and will restore to factory default settings.
Connects to Ethernet devices such as computers, gaming consoles, and/or routers/hubs
ETHERNET
using an RJ45 cable. Each Ethernet port on the back panel of the device has an LED to
1-4
indicate its status when an Ethernet-enabled device is connected.
Connects to the cable outlet (with the cable provided by your service provider), or a cable
CABLE
splitter connected to the cable outlet.
TEL1
Connects to standard telephones using an RJ11 cable. Telephone service must be enabled
TEL2 by your service provider.
PWR
Connects the power cable to the device. Use only the power cable provided with the
(POWER) UBC1329AA00.
Connects to an OPTIONAL external battery backup unit. The battery is not included in the
product packaging. Subscribers must contact the service provider to obtain a battery.
BATT
Battery supports continuous voice service during power outages, and provides up to 24
(BATTERY)
hours standby time, and 5 hours talk time with one line active. Actual performance is
affected by battery age and operating environment.
1.6

LED Behavior

The following tables summarize the behavior of the LEDs on both the front and
rear panels of the UBC1329AA00.
FRONT PANEL
LED Color
GREEN
POWER
Ubee UBC1329AA00 Advanced Wi-Fi 6 Voice Gateway User Manual • February 2021
Description
On – Internal power-on completed successfully.
Flashing – Power-on failed. NOTE: The LED blinks briefly immediately after
powering on the device.
Off – No power supplied to the device.
6