D3.1 WiFi 6 eMTA Quick Installation Guide UBC1330AA00 • SAFETY NOTICES Connect an Ethernet cable (supplied) to one of the ETHERNET Grounding the Device: Install the cable modem to include ports on the back panel of the modem and connect the other grounding the coaxial cable to the earth as close as practical to end to the Ethernet port of a PC.
Page 3
UBC1330AA00 Quick Installation Guide • DEVICE WALL MOUNT INSTRUCTIONS 161.8mm (6.37 inches) You can mount the UBC1330AA00 on a wall using the 2 mounting brackets on the side of the device. Two round or pan head screws are recommended. See the figure below for measurements. Label Size in Millimeters (mm) 7.2 +/- 0.5...
Page 4
UBC1330AA00 Quick Installation Guide • • UNDERSTANDING DEVICE CONNECTIONS AND BASIC MODEM INFORMATION BUTTONS Example of Cable 00:71:CC:8E:54:C7 RF MAC Address The rear and front panels of the UBC1330AA00 have the following connections and buttons: 12.13.1002.uni-r16.03. Firmware Version RESET: Use to reset the device.
Page 5
UBC1330AA00 Quick Installation Guide • LED BEHAVIOR COLOR DESCRIPTION FRONT PANEL ON - Internal power-on completed successfully. POWER GREEN FLASHES - Power-on failed. Note: LED blinks briefly immediately after powering on the device. OFF - No power supplied. DS/US FLASHES - DS and US scans in progress.
UBC1330AA00 Quick Installation Guide • FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT • FCC regulations restrict the operation of this device to This device complies with Part 15 of the FCC Rules. Operation is indoor use only subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any •...
Need help?
Do you have a question about the UBC1330AAOO and is the answer not in the manual?
Questions and answers