UBC1310BA10 Quick Installation Guide Advanced Wireless Voice Gateway Subscriber User • • SAFETY NOTICES INSTALLING THE MODEM Grounding the Device: Install the cable modem to include 1. Connect a coaxial cable (not supplied) to the CABLE connector grounding the coaxial cable to the earth as close as practical to...
Page 3
UBC1310BA10 Quick Installation Guide • DEVICE WALL MOUNT INSTRUCTIONS You can mount the UBC1310BA10 on a wall using the 2 mounting brackets on the side of the device. Two round or pan head screws are recommended. See the figure below for measurements.
Page 4
Firmware Version 9.59.1003 the device, hold for less than 5 seconds. To reset to factory default settings, hold for more than 5 seconds. The UBC1310BA10 will DOCSIS 3.0/2.0/1.1/1.0 certified reset and reboot. WARNING: Resetting to factory defaults will PacketCable 1.5/2.0 compatible...
Page 5
- An Ethernet device is connected to the UBC1310BA10 at 1000 Mbps speed. ETHERNET GREEN ORANGE - An Ethernet device is connected to the UBC1310BA10 at 10/100 Mbps speeds. ORANGE (rear panel) FLASHES (GREEN or ORANGE) - Data is being passed between the UBC1310BA10 and the connected Ethernet device. www.ubeeinteractive.com...
UBC1310BA10 Quick Installation Guide • FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is FCC Caution: subject to the following two conditions: (1) This device may not Any changes or modifications not expressly approved by the party...
Need help?
Do you have a question about the UBC1310BA10 and is the answer not in the manual?
Questions and answers