2.5 Remote Control Antenna Angle
(1) Adjust the angle of the remote control antenna and try to face the flight
direction of the aircraft as much as possible.
(2) Long-distance state, the distance between the two antennas is properly
tightened to maintain the antenna directivity.
(3) Closer Sate, the two antennas are properly separated to maintain a wide
receiving range.
(4) Do Not Form an occlusion or cross between the antennas.
2.6 Transmitter Calibration
Start Calibration: Push and hold both sticks to the upper left corner as shown in picture
below, and power on the transmitter, the transmitter will enter calibration state and start
Beeping; release the power button and sticks.
Calibrate Sticks: Rotate both sticks in circles to their maximum travel for at least
three times, and release the sticks
Exit and save calibration: long-press any button except the power button until the
remote controller stops beeping and the screen lights on
11