Figure 2 Tabs On Enclosure - Mircom OpenBAS-HV-NX4AO Installation Manual

To remove the circuit board from the enclosure
Caution: Risk of Electric Shock. Disconnect the mains power and disconnect the
controller from all wiring before opening the enclosure.
!
Attention: Always hold circuit boards by the edges to prevent damage from static
electricity. Always wear an anti-static bracelet when handling circuit
boards.
1. Insert a flathead screwdriver under the tabs on the enclosure, shown in Figure 2, in order
to lift the tabs and remove the base.
Figure 2 Tabs on enclosure
Installation
9