PACMotion™ PSD Installation and User Manual
GFK-3168A
protective earth (PE) wiring. When installing or replacing cables, use only standardized
components, which complies to the specifications in chapter 7.12 "Cable and Wire Requirements".
Note: The ground symbol, which you will find in all the wiring diagrams, indicates that you must
take care to provide an electrically conductive connection with the largest feasible surface area
between the unit indicated and the mounting plate in the control cabinet. This connection is for the
effective grounding of HF interference, and must not be confused with the PE-symbol (PE =
protective earth, safety measure as per IEC 60204).
5.6.1.1
Use the following connection diagrams:
Mechanical Installation
•
Overview (all connections):
•
IC830DP variant
•
Shielding:
(➜ # 98)
•
Mains power: (➜ # 105)
•
DC Bus Link:
(➜ # 108)
•
Motor:
(➜ # 116)
•
Feedback:
(➜ # 121)
•
Electronic gearing:
•
Encoder emulation:
•
Digital and analog inputs and outputs: (➜ # 146) Service interface:
•
Motion bus interface (➜ # 182)
(➜ # 83)
(➜ # 138)
(➜ # 140)
Section 5
September 2020
(➜ # 172)
54