Table of Contents
Advertisement
VERMICULITE (COARSE) - to be set by Gasfitter
APPLYING THE VERMICULITE: (
Apply with care a thin layer of Vermiculite over the Burner, just enough to cover the Burner Tray only .
NOTE: If the burner flame is uneven, the Vermiculite may need to be changed or sifted to remove the smaller pieces that can block the burners
holes. The smaller pieces can cause uneven burn and the unit to run dirty.
COALS AND LOGS - to be set by Gasfitter
Gloves should be worn when handling ceramic fibre Coals & Logs: as the carbon on the coals can stain the surroundings.
HELPFUL HINT: When use metal tongs when hot.
Apply a thin layer of Vermiculite over the burner, just enough to cover the burner tray only, as shown above.
1: Bottom Row: Assemble 2 Bottom Rows of coals onto the Vermiculite Base. 2: Top Row: Assemble 2 top rows of coals onto the bottom
1: bottom row
Each
tioned with the torn (roughest) facing outward Ensure coal positioning does not
directly block the 3 Flame Pilot .
The placement of the coals & logs may vary to make an even flame pattern.
Logs and twigs may be scattered to achieve best visual effect .
Model
SG / EG 600
SG / EG 700
SG / EG 780
SG / EG 900
SG / EG 1100
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
17
coarse -
must be larger than the burner plates holes so not to block them)
2: top row
coal
randomly
Number of Coals per Row
Bottom
Top
5
6
8
10
11
All Dimension are in mm.............Copyright ©
General Coal orientation for optimum effect.
row.
Slide R & LH Grate
Pins into Holes located
on the Burner Side
plates .
Model SG780 Shown: Total number of coals will vary per model.
posi-
Number of Rows
Bottom
4
2
5
2
6
2
9
2
10
2
29 March 2021
Total Coals
Top
Total
2
18
2
22
2
28
2
38
2
42
Advertisement
Table of Contents
