Bottom Row - Warmington SG 700 Installation Instructions Manual

VERMICULITE (COARSE)
APPLYING THE VERMICULITE:
Apply with care a thin layer of Vermiculite over the Burner, just enough to cover the Burner Tray only .
NOTE: If the burner flame is uneven, the Vermiculite may need to be changed or sifted to remove the smaller pieces that can block the burners
holes. The smaller pieces can ,cause uneven burn and the unit to run dirty.
COALS AND LOGS
Gloves should be worn when handling Ceramic Fibre Coals & Logs. The carbon on the coals can stain the surroundings.
HELPFUL HINT: Use metal tongs when HOT.
Apply a thin layer of Vermiculite over the Burner, just enough to cover the Burner tray only as shown above.
1 : Bottom Row: Assemble 2 bottom rows of coals onto the Vermiculite base. 2 : Top Row: Assemble 2 top rows of Coals onto the

1: Bottom Row


Each Coal randomly positioned with the Torn (roughest) Face Outward Ensure Coal positioning does not directly block the 3 Flame Pilot .

The placement of the Coals & Logs may vary to make an even flame pattern.

Logs and twigs may be scattered to achieve best visual effect.

Fit Burner grate by sliding R & L side metal pins on grate, into holes located on burner side plates, as shown below.
Model
SG / EG 700
SG / EG 780
SG / EG 900
SG / EG 1100
13
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
(To be set by Gasfitter)
(Coarse - must be larger than the burner plates holes so not to block them)
(To be set by Gasfitter)
2: Top Row
Number of Coals per
Bottom Top
6 5
8 6
10 9
11 10
All Dimension are in mm.............Copyright ©
General Coal orientation fro optimum effect.
bottom row.
Slide R & LH Grate
Pins into Holes locat-
ed on the Burner Side
plates .
Model SG780 Shown: Total number of coals will vary per mod-
Number of Rows
Bottom Top
2 2
2 2
2 2
2 2
6 October 2016
Total Coals
Total
22
28
38
42