Table of Contents
Advertisement
3.7
Troubleshooting
Fault
The press machine is not ready for
operation after the On/Off button
is pressed.
The press connector is incorrectly
pressed.
Oil escapes from the press
machine.
The motor runs, but the press
machine does not complete the
pressing.
* Remove the incorrectly or incompletely pressed press connector from the installation.
** Send the press machine to your nearest service partner for inspection and maintenance.
3.8
Care and maintenance
Pressgun 6 PlusPress machine with rechargeable battery and Bluetooth interface
The roller head has not yet touched the press jaw. The press
n
machine has not yet built up any pressing force.
There is a malfunction. The press machine cannot complete the
n
pressing.
▶
Release the Start button to interrupt the pressing.
▶
Actuate the Reset button to return the roller head to its initial posi‐
tion.
In case of malfunction, check the following potential causes:
Cause
The battery is fully discharged or
faulty.
The battery is not correctly
inserted.
The press jaw dimension does not
match the press connector.
The press jaw was not positioned
square to the pipe axis on the
press connector.
The press contour is incorrect.
The press machine has a fault.
A seal in the casing is faulty or
there is a mechanical problem.
The oil level is too low.
The tools are subject to normal wear and tear; for this reason, they must
be maintained in regular intervals. The maintenance and servicing of the
tools must be carried out by service partners authorised by Viega.
Solution
Use a fully charged battery.
Check it is correctly located in the
mounting bracket.
Use a press jaw that matches the
press connection dimension.
Make sure that the press jaw is
positioned square to the pipe axis
on the press connector.
Repeat the pressing*.
Check the press jaw and have
repaired as required.
Repeat the pressing* with an
operational press jaw.
**
**
Handling
27
Advertisement
Table of Contents
