Table of Contents
Advertisement
Motion Sequencing 2.0
Motion Sequence Utility
Cut Steps, Copy Steps, Paste Steps, Insert Steps
To cut, copy, paste, or insert Steps to either a single Lane or all Lanes:
1.
From a Motion Sequence Lane page, use
2.
Select an Action such as Cut Steps or Insert Steps.
3.
Set the Scope as desired, to apply the Action to all Lanes or to only the current Lane.
4.
Set the other parameters (From Step, Through, etc.) as desired.
5.
Press
ENTER
to execute the command.
Clear
This Action allows you to reset either a single Lane or all Lanes to their defaults. There are two choices for what to
clear:
Steps & Lane Settings resets all of the Step data and all of the Lane parameters, such as Loop Start and Loop End, to
their defaults. Any modulation routings to the Lane parameters will also be erased.
Step data only will leave the Lane settings intact, but reset all the individual Steps. Use this to retain previous settings
for modulation, specific loop points, and so on.
To use Clear, follow the general instructions under "Cut Steps, Copy Steps, Paste Steps, Insert Steps," above, selecting
Clear as the Action.
Scale Timing
This Action is available only when entering the Motion Sequence Utility page via the Timing Lane. It allows you to edit
all of the Timing Lane Step Durations at once, to make the sequence longer or shorter. If you want to change this in
real-time, use the Timing Lane Speed parameter instead.
PAGE+
to go to the Lane Utility page.
44
Advertisement
Table of Contents
