Table of Contents
Advertisement
Motion Sequencing 2.0
•
One value is recorded per step; for finer resolution in time, use a faster timing lane.
•
For playback closest to the original knob movements, leave the Lane's Transition set to Linear (the default).
Motion Sequence editing
Editing Lanes
The Lane controls which of its Steps are played, and how they loop. Changing the Loop Start or Loop End, for
instance, may significantly change the character of the sound; see "Standard Lane Controls" on page 34. Some Lanes
have special parameters in addition to the standard controls, as described in the following sections.
Editing Steps
There are up to 64 Steps per Lane, in four banks: A1-A16, B1-B16, etc. To view and edit individual Steps:
1.
Select the desired Lane by holding SHIFT and pressing one of buttons 10-16.
For example, to select Seq Lane A, press SHIFT-13.
2.
Press the
SEQ STEPS
The 16 buttons at the bottom of the panel now select Steps. The current Step's LED is brightly lit; Steps within the
programmed loop range (ignoring modulation) are also subtly illuminated.
3.
To select Steps in the current bank, press buttons 1-16.
or:
To select from a different bank, first hold either
bank. Buttons 1-16 will then blink; press one to select a Step in the new bank.
As you select different steps, the current parameter remains the same. For instance, if you are editing the Pitch for a
number of steps, you can quickly select Steps in succession, editing the Pitch via the value knob.
4.
Edit as desired using the onscreen controls (cursor and
Step Solo mode
Step solo mode makes the Lane temporarily loop on the selected Step, for auditioning values or shapes,
troubleshooting, etc.
To enter Step Solo mode:
1.
Hold
ENTER
and press a Step button.
Both the Step button and the current Lane's button will blink.
The Motion Sequence will play as if that Lane was set to loop on the selected Step. Other Lanes will continue to play
normally. If you select other Steps in the current Lane, solo will follow the selected Step.
To exit Step Solo mode, hold
Only one Lane at a time can be in Step Solo mode. If you enter Step Solo mode for a second Lane, the first Lane's Step
Solo mode is turned off automatically. Changing to a different Layer also turns off Step Solo mode.
button, so that it is lit.
ENTER
and press any Step button, or the current Lane's button.
SHIFT
or
SEQ STEPS
and then press 1/2/3/4 to select the
VALUE
knob).
31
Advertisement
Table of Contents
