Wave Sequence Utility; Cut Steps, Copy Steps, Paste Steps, Insert Steps, Add Steps To End; Scale Timing - Korg wavestate Owner's Manual

Wave Sequencing 2.0
Value * Random +: The Step's Value is scaled by a unipolar random amount. If the Value is positive, the output will be
positive; if the Value is negative, the output will be negative.
Value + S & H Mod: The Step uses the programmed value, and modulation is updated only at the start of the Step. For
instance, if an LFO is modulating Value, only the LFO's amplitude at the very start of the step matters; you will not
hear the LFO's shape during the step.
Value
[-100...100%]
This sets the output level for the Step.
Probability
See "Step Probability" on page 21.

Wave Sequence Utility

Cut Steps, Copy Steps, Paste Steps, Insert Steps, Add Steps To End

To cut, copy, paste, insert, or add Steps to either a single Lane or all Lanes:
1. From a Wave Sequence Lane page, use PAGE+ to go to the Lane Utility page.
2. Select an Action such as Cut Steps or Add Steps To End.
3. Set the Scope as desired, to apply the Action to all Lanes or to only the current Lane.
4. Set the other parameters (From Step, Through, etc.) as desired.
5. Press ENTER to execute the command.

Scale Timing

This Action is available only when entering the Wave Sequence Utility page via the Timing Lane. It allows you to edit
all of the Timing Lane Step Durations at once, to make the sequence longer or shorter. If you want to change this in
real-time, use the Timing Lane Speed parameter instead.
29